AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
How to calibrate bendix abs9/4/2023 Apply ignition power, and wait 30 seconds. “ To perform a calibration procedure of the Brake Demand Sensor(s), ensure that the air system is fully charged. To do this procedure you need to follow these instructions: This procedure is found on page 43 of the Bendix troubleshooting manual. What that blink code is telling you is that you need to perform a static sensor calibration procedure. The blink code for Bendix for this specific fault code will be 24-6. The problem you are facing will have something to do with the brake sensors that enable your ABS system to work properly. One explanation would be- Plausibility error brake demand sensor but if you have the Bendix brand of ABS system in your vehicle, then you are looking at PS Not Calibrated and it comes under the heading rake Demand/Load Sensor DTCs.
0 Comments
Read More
Leave a Reply. |